Uwe Trulson

Thank you Bernard, John and Michael, the Balance is well, the setup wans not changed. The only one change before was the wrong turn on the motor in fixed position. Now i deleted the installation and the user files of Autoslew and install and setup all again. The error is fixed. The Mount runs well. Best regards Uwe

Hello, It started when I had accidentally turned on the motors when the telescope was still parked horizontally in west facing and secured with a strap against tilting. The Auto Find course did not go with it. Have it canceled everything turned off and on again. Thereafter, in the correct position to the home Find again started. The Autofind ran through well. However, the Home Find then hectic telescopic movement first to the east and then west until it strikes against the column. That happens now every way. The Mount is balanced well. It runs well any time before. Thank you for help Uwe Here is the Log: -------------17:19:06------------ Axis RA/AZ reported the following Problem: Position Error -------------17:19:06------------ RA/AZ calibration failed ! -------------17:17:10------------ Welcome Autoslew Vers 5.1.1.6 -------------17:17:10------------ CLServo Vers.1.1.3.3: 2 axis init OK -------------17:17:08------------ Pointing-Configuration C:\ProgramData\ASA\Autoslew\erstes.cfg loaded -------------17:17:08------------ Loaded Ini-File C:\ProgramData\ASA\Autoslew\Autoslew.ini