VOBST

The problem has not yet been solved. Perhaps the following new information helps: Prerequisites: Homefind io, basic calibration at the zenith position as described in the manual (location adjusted via GPS, counterbalance bar points eastward with view of the plugs, telescope consequently to the west to zenith, synchronized to P1, Set New Homefind executed) . Display in AutoSlew at this location: Az = 180 (N = 0) H = 180 (S = 0) Moving the telescope in MAXIM leads to a pier flip. Display in AutoSlew after: Az = 180 (N = 0) H = 0 (S = 0) Is the solution to the problem to be found here? If so, what is to be done?

Many thanks for the answer. But there must be another reason, since I had chosen "astrooptik server telescope".

Thanks for the reply and the hint. Yes, the setting was done for the right side (East). I checked it again, there is no influence.

I want to control my system with Maxim. There is a problem, for which I find no expla­nation. Basic data: ASA DDM60pro with AutoSlew 5.2.1.9; Maxim DL pro 5.24, WIN 7 In AutoSlew: Motor on, Io, HomeFind Io, telescope in park position on the west side, counter­weights corresponding to the east side, movement of the telescope via the Move control field in AutoSlew in all directions as expected. In Maxim: Telescope Connect Io. In the "Telescope" card type control via the move control field e.g. to the north leads to a pier flip (telescope corresponding to the east side, counterweights on the west side), then renewed control to the north leads to a correct north movement. Settings in the card type "SETUP, Telescope, Options, Mount Type": German Equato­rial Settings in the "SETUP, Telescope, Options, Side of Pier" card type: ASCOM normal (all others tested without modification). Does anyone have an explanation or solution for me?