Custom tuning of the siderial speed settings in motor tuning.

[rharter]

Following the latest manual of autoslew I tried to tune the motor parameters with the custom settings with 0.004.

I noticed that the general deviation of the x-axis is quite more flat than with the siderial settings. But  I can not verify the status of my custom adjustment after save teleskope. If I stored it with "save telescope" and load it again the automatic setting in "test speed settings" is  siderial speed and not my custom speed settings. Which one is used of the program after storage? How can I be certain that my custom speed adjustment is in use? Thanks for your help.

Ralph

[GeorgeCarey]

_{As far as I am aware, Autoslew only uses two settings of motor parameters - tracking and slewing.}

_{The 'custom' setting is a speed you can use to fine tune the PID values, but I don't think that speed ever gets used.}

_{I am sure someone will correct me if I am wrong.}

Edited November 18, 2013 by GeorgeCarey