laurentk Posted August 26, 2021 Report Share Posted August 26, 2021 Hello on my last session the AAG Cloudwatcher send a NOT SAFE ALERT during an Autofocus. SEQUENCE PARK the TELESCOPE an CLOSE DOME OK but DON'T STOP. Autofocus continue and at next SEQUENCE continue so the telescope slew to the position and hit the dome In sequence the option Autofocus Error Procedure during Sequence was set to ignore. I change it to Shutdown to prevent moe issue. I attach the sequence log. Best Regards sequence log.txt Link to comment Share on other sites More sharing options...
Corpze Posted August 27, 2021 Report Share Posted August 27, 2021 Thanks for the heads up! do you think that if you hadn’t been in a focus routine, everything would have been ok with the shut-down? Link to comment Share on other sites More sharing options...
laurentk Posted October 10, 2021 Author Report Share Posted October 10, 2021 Sorry for the delay I think yes ! Link to comment Share on other sites More sharing options...
DaveS Posted November 22, 2021 Report Share Posted November 22, 2021 I was going to start my own thread on this as I had the same error last night, and I think on an earlier run, but clear nights have been few and far between so I'm not sure when it was. Cloudwatcher flagged up NOT SAFE and sequence looked like it had shut down but then tried to continue the exposures with the roof closed. Autoslew of course then threw up Position Errors. My exposure folder shows two bad subs of 15 mins each. 2021_11_21_16h43m.txt Autoslew Log 2021_11_21_16h44m.txt Sequence Log. The Autofocus wasn't involved in this error. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now