following the Autoslew manual I have done all the mentioned adjustments for a stationary mount to start again only with the Homefind referencing and the corresponding pointing file.
After a new start I always have a deviation of about 15 arcsec in RA of the former synchronized and centralized star with the "Set new Homepostion" and saving procedure. I will not again synchronize following the manual.
Where is my fault or has anyone else the same experience and what possible solution did you find?
Right now I must always following the whole procedure after a new start of synchronization and "Set new Homeposition" to have a star centalized without deviation from the beginning. By the way,certainly nothing was changed during the stop at the system.
Question
rharter
Hi all,
following the Autoslew manual I have done all the mentioned adjustments for a stationary mount to start again only with the Homefind referencing and the corresponding pointing file.
After a new start I always have a deviation of about 15 arcsec in RA of the former synchronized and centralized star with the "Set new Homepostion" and saving procedure. I will not again synchronize following the manual.
Where is my fault or has anyone else the same experience and what possible solution did you find?
Right now I must always following the whole procedure after a new start of synchronization and "Set new Homeposition" to have a star centalized without deviation from the beginning. By the way,certainly nothing was changed during the stop at the system.
Thanks
Kind regards
Ralph
Link to comment
Share on other sites
16 answers to this question
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now